[R-390] Bridge Rectifier Identification?

[ToddRoberts2001 at aol.com]

In a message dated 8/11/2007 8:15:00 AM Eastern Standard Time, 
rbaldwin14 at nc.rr.com writes:
Does anyone have the specs. On a bridge rectifier with the following
nomenclature:
7914    VS148?
The manufacturer’s logo is a white circle with a stylized V in the center.
I’d like to use these to replace the selenium rectifiers in the R-390 and
390A, but am in doubt as to their specs.
The units are quite small, about ¾” square.
Thanks in advance for any information you might have.
Rich Baldwin

KD6VK
 
Practically any bridge rectifier made nowadays would handle the low voltage 
and current requirements of the R-390 and R-390A antenna relays. Use a DVM to 
determine the polarity of the diodes in the bridge.
 
73 Todd WD4NGG



************************************** Get a sneak peek of the all-new AOL at 
http://discover.aol.com/memed/aolcom30tour