[R-390] 0.5-8.0 Low Sensitivity (Long)

[ToddRoberts2001 at aol.com]

All else works fine now and I'm tempted to just leave well enough alone. 
However, I'm 
puzzled why fresh trimmers and new micas at spec values cannot get two peaks 
during 
alignment.

Got any ideas?

Dan
WB4GRA

Have you tried screwing in the slugs a few more turns? What happens when you 
screw in the slugs a few more turns? Does the signal continue to peak or does 
it start to fall off? If it starts to fall off then the single peak would 
appear to be near correct even though you only get one peak when the slug is 
maxxed out. I wouldn't worry too much about a single peak if the sensitivity is 
back to normal. 73 Todd WD4NGG