[R-390] Recapping question

[n4buq at knology.net]

On Wed, 06 Sep 2006 15:13:28 -0400, Roy Morgan <roy.morgan at nist.gov> wrote :

> At 02:58 PM 9/6/2006, n4buq at knology.net wrote:
> >Actually, lug B has a few more component soldered to it
> 
> 
> Barry,
> 
> While you are at it, loosen and re-tighten those ground lugs, in fact do 
it 
> for any and all you can see. Same for any tube socket mounting rings that 
> are used as grounds. Just this tightening can solve all sorts of strange 
> symptoms.
> 
> Roy

That's good advice.  I was noticing in the picture that where the other 
ground lug goes (lower right hand corner of the picture) it appears there 
is some kind of corrosion(?) buildup underneath where the old ground lug 
went.  I didn't notice that until I looked at the picture.  It could just 
be the picture but I'm definitely going to check that out before I replace 
the solder lug.

Thanks,

Barry - N4BUQ