[R-390] make knobs for R-390 series?

[Tom Norris]

On Oct 3, 2006, at 10:09 AM, <mfisch at kent.edu> <mfisch at kent.edu> wrote:
>
> The discussion about knobs has gotten me thinking.  There is a student
> chapter of the Society of Manufacturing Engineers at Kent State that I
> have some affiliation with.  They are always looking for ways to fund
> their other projects and have access to CNC lathes and mills, powder
>


Hank Arney here on the list already offers such a thing, he has all  
three sizes, CNC machined, powder coated and pretty much at what it  
cost to have them done - it's not a project he's making any money  
on.  If the students are going to do them as a fund raiser, I'm not  
sure they'd offer them for much less.  He has machined gear clamps,  
oldham coupler disks, and R-390 "green gears" as well. (unless he's  
out of some of them)

One thing I don't think he has are oldham coupler disks for R-390  
crystal decks and the odd coupler the R-392 uses for it's bandswitch  
shaft.  Those might some good short-run projects.
Maybe.

Just sayin...

Tom