[R-390] Re: New 'coffee' table

[Patrick Jankowiak]

Are not the Tinnerman nuts the same as the ones used for racks with 
large holes that are not tapped? I use cage nuts for those. I had to 
order about 300 of them to meet minimum order So far have used most of 
them too!

My stereo is in a 6.5' pdp11 rack.

Try here for Tinnermans:
http://boltproducts.ecreativeworks.com/tinnerman/nut-bolt-retainers.html

You might be looking for a cage nut though:
http://www.rackmountsolutions.net/Rackmount_Screws_Hardware.asp

Patrick



Roy Morgan wrote:

> At 10:23 PM 6/25/2006, Patrick Jankowiak wrote:
> 
>> Try googling 'vaxbar' for the matching wet bar from which 807's may be 
>> dispensed from a built in cooling system  ...
> 
> 
> See:
> http://toyvax.glendale.ca.us/~vance/vaxbar.html
> 
> This story reminds me that I have a DEC Disk Rack here.  It's a 
> convenient 4 feet tall, 19 inch rack size, and is equipped with nice big 
> casters. Only one problem: the side rails have un-tapped holes in them 
> meant for tinnerman nuts to hold the equipment in place, but no nuts!  
> These need to be very thick to slide over the very substantial rails.
> 
> I've searched for such nuts, but to no avail. Anyone have some?
> 
> Roy
> 
> 
> my R-39x's in place.
> - Roy Morgan, K1LKY since 1959 - Keep 'em Glowing!
> 7130 Panorama Drive, Derwood MD 20855
> Home: 301-330-8828 Cell 301-928-7794
> Work: Voice: 301-975-3254,  Fax: 301-948-6213
> roy.morgan at nist.gov --
> 
>