[R-390] IF slugs

[Barry]

The typical adjustment tool has a short tip that has the hex shaped business
end.  Further down the shaft, the tool relieved to a sufficiently small
enough diameter to clear the hex shape from the "upper" slug.  I hope that
makes sense...

Barry - N4BUQ

----- Original Message ----- 
From: <N4TUA at aol.com>
To: <r-390 at mailman.qth.net>
Sent: Monday, October 10, 2005 12:51 PM
Subject: [R-390] IF slugs


> Hello Again,
> I am getting some good input on the stuck slugs and I am tending to just
> leave them alone. I would wonder though if one was going to do the fixed
IF
> alignment. How do you get to those bottom slugs? What type of tool do they
take? I
> would think the tool would be smaller than the hole in the top slug and
would
> go down through to adjust the bottom slug. What type of tool does it take?
None
> like I have that is for sure.
>
> Thanks for the help, Collin
> _____________________________________________________________
> R-390 mailing list
> Home: http://mailman.qth.net/mailman/listinfo/r-390
> Help: http://mailman.qth.net/faq.htm
> Post: mailto:R-390 at mailman.qth.net
> Unsubscribe: http://mailman.qth.net/mailman/options/r-390
>