[R-390] R390 RF deck cover

[Brad Huff]

Is there someone in the group that has the fabricating tools to make a couple of these covers? I know Jack Sullivan needs one as well. I don't have one in front of me now but I did have the foresight to measure one that I saw at Dayton. These are close measurements-The basic piece is 12-1/16" X 8-3/8". Starting from the back come forward about 5/16" and then it steps up approx 1/8". Come forward about 6-13/16" then step back down approx 1/8". Come forward 1-1/4" then it has a lip that bends down an 1/8th or 3/16. Sorry to be so vague but the piece was on a radio and all I had was a crude tape measure.  

    _______________________
__I                                        I_______
                                                         I  Side view. Not to exact scale but it sort of gives you an idea. Holes are then drilled where they are needed. There was no printing on the top, I am not sure about the bottom side. If someone with a R-390 could verify these measurements it would be helpful.-Brad