[R-390] Diode Load Tap for Audio

[Flowertime01 at wmconnect.com]

Jim,

Opps, sorry last post was bad.

470K resistor and cap do work.

Been to the circuit and done it.
It does work as advertised, so you do have a hardware problem.


Some times you have to use a value other than 470K because of the load you are
working into for your amplifier.  As you have no audio, try a 47K or even a 
4.7K.
The amplifier input you are trying to drive may be a lot lower impedance than 
you expect. Watch out that you are not trying to drive a dynamic mic input 
that has a DC voltage associated with it. That will put a charge on the cap and 
cut the signal off also.

Roger KC6TRU


> 
> 
> 
>