[R-390] R-390 Progress - Schematic

[Dan Merz]

Roy,  worked like a charm.  I printed two pages and they looked to match up
ok.  This was the scale that I was trying to reach on the version that I had
but couldn't figure out how to do it easily.   I'll put the file on a disk
and print the whole thing on wife's laser printer,  which is quicker and a
little better than my vintage inkjet.  Then I can make a wall mural out of
it, hi.   Thanks,  Dan. 

-----Original Message-----
From: Roy Morgan [mailto:roy.morgan at nist.gov] 
Sent: Wednesday, May 04, 2005 1:49 PM
To: Dan Merz; R-390 at mailman.qth.net
Subject: RE: [R-390] R-390 Progress - Schematic

At 04:17 PM 5/4/2005, you wrote:
>...how to you get the scale to come out the same on all the print jobs 
>if you're fitting it to the page?

Dan and others:

I've just put the schematics only from the manual found on the Andy Moorer's
web site (jaminpower...) on my web site: 
http://home.comcast.net/~roysmorgan/

Go have a look and see if these pages work for you. .each page is 8-1/2 by
11 and should print more or less to match lines up.

Roy

- Roy Morgan, K1LKY since 1959 - Keep 'em Glowing!
7130 Panorama Drive, Derwood MD 20855
Home: 301-330-8828 Cell 301-928-7794
Work: Voice: 301-975-3254,  Fax: 301-948-6213 roy.morgan at nist.gov --