[R-390] BFO question
Osamu Hazawa
pomerol at mocha.ocn.ne.jp
Wed Jun 29 22:41:06 EDT 2005
Jim,
My BFO doesn't work too.
How can I find the center of the BFO frequency?
Is there any mark for mechanical center point on BFO?
Osamu Hazawa
http://www4.ocn.ne.jp/~pomerol/MyPage/menu0.html
----- Original Message -----
From: "Jim Miller" <jmiller1706 at cfl.rr.com>
To: "Kenneth" <crips01 at msn.com>; <r-390 at mailman.qth.net>
Sent: Thursday, June 30, 2005 8:22 AM
Subject: Re: [R-390] BFO question
> It is possible that the BFO knob could have been turned multiple times
> either way putting the BFO frequency way off. It could be oscillating OK
> but be way off frequency.
>
> ----- Original Message -----
> From: "Kenneth" <crips01 at msn.com>
> To: <r-390 at mailman.qth.net>
> Sent: Wednesday, June 29, 2005 4:51 PM
> Subject: [R-390] BFO question
>
>
>>I am going to get the BFO working on My R390A, once and for all. I have
>>the
>> Y2K manual, of course, but I need a little advice. Here is what I have;
>> the
>> BFO does not work, there is no calibration tone in the R390's audio but I
>> can hear it from the SBA-1 side band adapter, I can see a calibration
>> carrier in the signal strength meter on the R390. The tubes on the IF/RF
>> module test good, if I can trust my tube tester that is. Where do I
>> start
>> on this to figure out what is going on. I have replaced the two
>> questionable
>> caps in this module. The radio works fine otherwise. I have not been
>> too
>> motivated to repair the BFO because of the side band adapter.
>>
>> Ken
>> _____________________________________________________________
>> R-390 mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/r-390
>> Help: http://mailman.qth.net/faq.htm
>> Post: mailto:R-390 at mailman.qth.net
>> Unsubscribe: http://mailman.qth.net/mailman/options/r-390
>>
>
>
> _____________________________________________________________
> R-390 mailing list
> Home: http://mailman.qth.net/mailman/listinfo/r-390
> Help: http://mailman.qth.net/faq.htm
> Post: mailto:R-390 at mailman.qth.net
> Unsubscribe: http://mailman.qth.net/mailman/options/r-390
>
More information about the R-390
mailing list