[R-390] Fw: Fill in engravings

[pete williams]

Pete D . Williams
METUNG 3904
Australia
jupete at bigpond.net.au
From: "pete williams" <jupete at bigpond.net.au>
ToSubject:

Fill in engravings




 Don't know about the  lacquer sticks vs baking but have  found that
it hardens  up in time.

 my experience  with R-390A panel is to follow the proceedure that is
outlined in a back copy of  "ER".
1. Prime and paint the panel -lightly.
2.Use artists  white latex based paint. only  do a few  engravings at
a time .
3. Take windscreen squeegee and wipe off excess on one pass only.
4. using a  barely damp rag,  wipe of the squeegee lines without
disturbing the areas just filled .
5. wait about 15 mins  and using a  barely damp rag. lightly wipe over
the   engraved  areas until fairly clean. Don't press heavily and use
a rag with minimum nap - i.e  hairy .
6 leave for a few days to harden up and use a fine abrasive car polish
to remove the  last of the  white paint. - don't use excessive
force/pressure on any of these operations.
  7. wash with  soap and water and you're thru '

 Works every time for me  and I  wouldn't  worry/bother with any over
spray of  satin anything

 Cheers
Pete VK 3 IZ

Pete D . Williams
METUNG 3904
Australia
jupete at bigpond.net.au



-- 
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.323 / Virus Database: 267.8.6/33 - Release Date: 28/06/2005