[R-390] NEED HELP R-390

[Barry]

I wonder what the output voltage on your PTO runs with the 3TF7 in place?
Both of mine only put out a couple of volts, but I think they're supposed to
generate about 7 volts.  Apparently it takes very little injection signal to
keep things going and even my 2 or 3 volt units provide plenty of signal.
Not sure, though, how long the loop will continue after mine loses filament
power.  Perhaps I'll try that.

Sadly, one of my 3TF7s died recently.  I was aligning the IF and in the
process of pulling the xfmr shields at the time and I think something
shorted to the shield in the process.  Yeah, I should've turned off the
power when doing this, but I didn't think there would be a point that would
touch anything.  At any rate, the 3TF7 died when I heard the "buzz" while
pulling the shield off of one of the transformers.  Since the 3TF7 only
regulates the two filaments, I'm not sure how this would have caused the
3TF7 to blow.  Perhaps it was just its time to go?  At any rate, it is now
replaced with my trusty 47-ohm resistor bundle until I find another
reasonable replacement.  :(

Barry - N4BUQ

----- Original Message ----- 
From: "Tim Shoppa" <tshoppa at wmata.com>
To: <R-390 at mailman.qth.net>
Sent: Wednesday, June 15, 2005 10:46 AM
Subject: Re: [R-390] NEED HELP R-390


>> HOW DOES A R-390 RECEIVE WHEN BALLEST TUBE [TUR]3TF7 IS WEAK OR BAD?

> The PTO will not work.

I've pulled the (good) ballast tube from a working R-390A and I was
surprised how
long the PTO continued to "work":

A few seconds after pulling the tube, the PTO begins to drift enough to be
noticeable.
For the first coupld of seconds, I don't hear the PTO drift even when
listening to CW.

For ten or so seconds after that, the PTO drifts maybe a few hundred Hz but
keeps on working.

There's another few seconds where the PTO is drifting way way out from where
it originally was oscillating.

After about 15 seconds, finally the PTO stops oscillating and the radio goes
quiet.

My guess is that there is enough "gain margin" in the PTO design that even
though loop
gain drops dramatically as filament emission drops, still the oscillator
keeps on running.

Tim.
_____________________________________________________________
R-390 mailing list
Home: http://mailman.qth.net/mailman/listinfo/r-390
Help: http://mailman.qth.net/faq.htm
Post: mailto:R-390 at mailman.qth.net
Unsubscribe: http://mailman.qth.net/mailman/options/r-390