[R-390] Knob powder coating

[Roy Morgan]

At 01:18 AM 1/25/2005, Dan Arney wrote:
>You still have to strip them, smooth out the rough spots, remove the set 
>screw, plug them, mount them properly, remove the plugs and replace set 
>screws then fill in the white line.

Anchorites,

Let me see if I understand powder coating, in simple terms:

(After you do what Hank says, above)
... the powder gets glommed onto the piece by electrostatic charge, and you 
bake it to make it hard.

Issat right?

This reminds me of the recipe for elephant soup:

First get some elephant.
Then you put it in a pot, add vegetables, season to taste,
and simmer till done.

Now, that *sounds* simple enough...

Roy


- Roy Morgan, K1LKY since 1959 - Keep 'em Glowing!
7130 Panorama Drive, Derwood MD 20855
Home: 301-330-8828 Cell 301-928-7794
Work: Voice: 301-975-3254,  Fax: 301-948-6213
roy.morgan at nist.gov --