[R-390] Mechanical Alignment Part 01 Front Panel Bushings (rev A)

[Flowertime01 at wmconnect.com]

Miles Anderson, K2CBY

Thank you for the additional paragraph. watch for it the next time I post the 
full text.
Joe says I need to do these post in parts because the full post is two large 
for Yahoo mail to receive. I can do that for every one so watch these post to 
come in parts.

Roger L. Ruszkowski AI4NI (was KC6TRU yesterday)

Although it may have been said before, I always retighten the bushings as
the last step in front panel reassembly. I tighten all the panel to chassis
screws hard to establish the orientation of the front panel. Then I slide
the bushings forward on the shafts through the panel and attach the nuts
from the outside. After making each nut finger tight I verify that the shaft
turns freely and then dog down the nut, starting with the kilocycle shaft. I
check the free movement of each shaft before going on to the next.