[R-390] Mechanical Alignment Part 01 Front Panel Bushings (start)

[K2CBY-Optonline]

Although it may have been said before, I always retighten the bushings as
the last step in front panel reassembly. I tighten all the panel to chassis
screws hard to establish the orientation of the front panel. Then I slide
the bushings forward on the shafts through the panel and attach the nuts
from the outside. After making each nut finger tight I verify that the shaft
turns freely and then dog down the nut, starting with the kilocycle shaft. I
check the free movement of each shaft before going on to the next.

Miles Anderson, K2CBY
16 Round Pond Ln, Sag Harbor, NY 11963
k2cby at optonline.net