[R-390] Big Knobs

[Pat McGrath]

Hank

I need two of the big knobs for the R-390 receiver.

How can I contact you?







> 
> ----- Original Message ----- 
> From: <Flowertime01 at wmconnect.com>
> To: <r-390 at mailman.qth.net>
> Sent: Tuesday, December 13, 2005 7:14 PM
> Subject: Re: [R-390] Big Knobs
> 
> 
>> Hank,
>>
>> Thank you for this post.
>> I did not know you had these knobs available.
>>
>> Roger L. Ruszkowski
>>>
>>> Roger,
>>> I made large knobs out of 6061 bar stock and ran them on a CNC center
>>> and powder coated them.
>>> I sell them for $30.00 each and have about 30 left out of 2 runs of 100
>>> each. Plus some for the R-391 with holes in the center plus I made the
>>> locking pins for it and the ARR/15
>>> Plus I have a good supply of original knobs of all 3 sizes.
>>> Some sets of small and medium are available that have been stripped and
>>> powder coated.
>>>
>>> Hank
>>> KN6DI
>>>
>>
>>
>> _____________________________________________________________
>> R-390 mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/r-390
>> Help: http://mailman.qth.net/faq.htm
>> Post: mailto:R-390 at mailman.qth.net
>> Unsubscribe: http://mailman.qth.net/mailman/options/r-390
>> 
> 
> 
> _____________________________________________________________
> R-390 mailing list
> Home: http://mailman.qth.net/mailman/listinfo/r-390
> Help: http://mailman.qth.net/faq.htm
> Post: mailto:R-390 at mailman.qth.net
> Unsubscribe: http://mailman.qth.net/mailman/options/r-390