[R-390] Adjusting Z702 Tools

[Flowertime01 at wmconnect.com]

In a message dated 4/3/05 11:22:17 PM Eastern Daylight Time, N4BUQ at aol.com 
writes:

Is there a tool made to adjust the slug on Z702 (the can on the PTO)?

Barry,

All the tools I have seen for Z702 were from the teletype side of the shop.

We had a round soft iron rod that had a slot sawed into the end of it. The 
slot was wide enough to fit the flats. Most guys had a wrap of tape (heat shrink 
sleeve) around the end of the rod over the slot to keep the tool from 
slipping off it nut. The best one I seen was an El Cheepo screwdriver shaft cut off 
and slotted. I had been slotted with a Demerol tool grinding wheel because even 
cheep screwdriver shafts are fairly hard to saw.

Roger KC6TRU