[R-390] Parts Left From RF Deck Rebuild.

[Leigh Sedgwick]

Howdy,

Just finished up the rebuild of my R390A RF deck after
looking at all the pieces lying on my table since last
April.  I had meant to complete this activity before summer
but our weather was so good, well, I just didn't get back to
it.

Huge thanks to Scott Seickel for the excellent pictures and
instructions making this job doable after such a long
absence from the tear-down.  

I have the RF deck all back together now and mechanically
aligned.  Both the Mc and Kc mechanisms tune very smoothly. 
However, I am left with a few parts that I cannot account
for.  These parts are shown in the following picture:

   http://home.comcast.net/~bipi/miscpic/leftover.jpg

There were 2 shim washers and a slip-ring for both of the
ten-stop turns shaft that I used during the assembly.  So I
have 4 shims and a slip ring left over that I can't account
for.  Also, 3 other misc shims.  Finally, I have an extra
shaft spacer like that used on the veeder root counter Mc
change gear.  Early on I tore apart an old junker RF deck to
get some needed parts and it is possible that these are from
that activity but I just can't remember.  Can anyone guess
if I have missed something?

BTW, if anyone is interested, here are before and after
pictures...

   http://home.comcast.net/~bipi/miscpic/geargunk.jpg

   http://home.comcast.net/~bipi/miscpic/finished.jpg

Thanks again to all those who helped with the Y2K manual and
to Scott for his excellent pictures and instructions.

73 de Mike
K7PI
Mercer Island, WA