[R-390] 390a - Switch Wafer Alignment

[Bryce Ringwood]

Hi,

Thanks to Dallas Lankford and Pete Wokoun,sr. 

Concensus is that there's a lot of slop on the shaft and some good can
be obtained by putting a shim one side of the shaft under the misaligned
wafer. Dallas also cautions about attempting to align the crystal
oscillator section wafers with the unit detached from the rest of the RF
unit. I followed their advice and aligned it as best as I could without
dismantling the wafer mounting screws. So far its working quite nicely.

- Bryce

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
MailScanner thanks transtec Computers for their support.