[R-390] Microswitch replacement

[Bob Camp]

Hi

Sorry you can only download the MicroSwitch service pack *if* you have 
a current support agreement in place and are the listed support 
administrator for your site. In addition any benchmarking using the 
contents is strictly forbidden unless authorized in writing ....

It's pretty common to have an "extra" switch position. Generally it 
shows up past the CAL position. It was put there to allow you to turn 
on the SSB option if I remember correctly ....

The *big* thing to do when you replace the microswitch is to make sure 
that it's nice and tight. You want a good positive action on the 
switch. If it loosens up you can get a partial closure. This is a 
really fast way to kill your nice new switch ....

	Enjoy!

		Bob Camp
		KB8TQ




On Apr 16, 2004, at 10:39 PM, Scott, Barry (Clyde B) wrote:

> No, but it sounds like you do need to go to the MicroSwitch website and
> download the latest Service Pack.
>
> Barry(III) - N4BUQ
>
>
>
> Letsee, I have OFF, STANDY BY, AGC, MGC, CAL.  No Start......
> Is My 67 EAC an early module or mebbe a depot dawg?
>
> Jim
>
>> Only on the WinSwitch96 and newer models....
>>
>> heehee
>>
>>> $10 per switch, you say?  Oh, I see now, "MicroSwitch".  Hmmm, when
> you
> go
>>> to turn off your radio now, do you have to press "Start" first?
>>>
>>> Barry(III) - N4BUQ
>
> _______________________________________________
> R-390 mailing list
> R-390@mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/r-390
>