[R-390] Installing replacement PTO

Mon, 6 Jan 2003 19:06:07 -0500

Forget it.  You are going to have to put it in the radio and
set it.  Even if I set my PTO at a certain value and shipped it
to you it would not be aligned to your set.  It is very easy to 
do with a frequency counter, but in a bind you can set the PTO
by shooting for maximum output when tuned to a local station.
See the Y2K manual for setup instructions.

Scott

----- Original Message ----- 
From: "Larry and Jody Cogan" <[email protected]>
To: <[email protected]>
Sent: Monday, January 06, 2003 6:48 PM
Subject: [R-390] Installing replacement PTO

> I have just acquired a replacement Cosmos PTO.  I have no real
> information about it, other than it "was removed from a working
> receiver".  Is there a mechanical way to determine if it is set at (or
> near) 2455 khz?  The oldham coupler on the PTO was "unrestrained",
> i.e., not taped to prevent rotation,  etc.
> 
> Thanks, Larry
> 
> 
> _______________________________________________
> R-390 mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/r-390