[R-390] Big Mistake Please Help

[Ronnie Davis]

Hello
Well all was going well with the Capehart R-390A until last night. I pulled
the RF Deck out to start working on it, and after cleaning for sometime, I
remembered that I did not set the PTO to 8 Mhz before pulling the deck?
After I remembered that I just thought about messing up big time! I had
already been turning the Mhz change knob to clean the deck, and the
kilocycle change knob has also been turned for cleaning. So the problem is,
that I have no idea where the PTO was at when I pulled the RF Deck? I knew
better than this, I knew from the manuals and the videos that I should have
put the PTO on 8 Mhz but while in the heat of working on it I just slam
forgot. Please tell me there is a way to find out where the PTO is so I can
install the RF Deck when I finished with it. Sure hope I did not mess up to
bad? Again a Stupid Beginners Mistake
Thanks again
Ronnie
KE4VPN