[R-390] Correct Ballast makes a difference 8^)
Ray V.
[email protected]
Sat, 02 Aug 2003 08:37:20 -0400
Phil, hold onto the 3TF4, it is used in the Collins KWS-1 SSB
transmitter and I'm sure someone with a KWS-1 may have a need for it at
some point.
73, Ray W2EC "http://w2ec.com/W2EC.html"
Phil Atchley wrote:
> Hi.
> Today the "correct" (3TF7) ballast arrived for my '67 EAC and the set is
> happily perking along with it installed. After installing it a visual
> checked showed that it had only just a couple very small spots
glowing, same
> as I'd expect to see in a properly working ballast. The one that
came in
> the set (3TF4) was glowing a nice cherry red along the entire length
of it's
> filament.
>
> In checking the tuning of the set, it doesn't appear to have made any
> difference in overall performance or calibration. That is about as I
> expected as the voltage applied to the BFO/PTO was about 11.5 Volts,
not all
> that low for two tubes in series. (I didn't check to see what it is
now).
>
> Now, back to DXing with the set.
>
> ****************************************************
> * DXing WITH THE FOLLOWING EQUIPMENT. *
> * RECEIVERS: *
> * '67 EAC R-390A Military surplus. *
> * YAESU VR-5000 Wideband, "DC to Daylight". *
> * REALISTIC DX-392, KNIGHT-KIT R-100A. *
> * Others that pass thru or are waiting repair. *
> * Homebrewed Ant/Rig switchbox with filters/Amp. *
> * ANTENNAS: *
> * Coil Loaded 18.5 Meter Long Sloper. *
> * Roof mounted Hustler 6BTV 6 band Vertical. *
> * Scantenna Scanner antenna at 7 Meters high. *
> * LOCATION: Merced, Central California. *
> * COORDINATES: 37.18N 120.29W CM97sh. *
> ****************************************************
>
>
>
> ---
> avast! Antivirus: Outbound message clean.
> Virus Database (VPS): 8/1/2003
> Tested on: 8/2/2003 4:55:09 AM
> avast! is copyright (c) 2000-2003 ALWIL Software.
> http://www.avast.com
>
>
>
> _______________________________________________
> R-390 mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/r-390
>
>