[R-390] Re: Refinishing meters

Tue, 29 Apr 2003 08:02:13 -0500

This one has four shoulder screws that hold the round back to the square
face.  I didn't see this until I removed the thick gasket.  I'll get a
picture on the website tonight (unless I forget...)

Barry(III) - N4BUQ

-----Original Message-----
From: David P. Goncalves [mailto:[email protected]]
Sent: Tuesday, April 29, 2003 7:39 AM
To: [email protected]
Subject: [R-390] Re: Refinishing meters

Question: Does the joint between the circular case and square face have a
recessed metal ring with 4 notches in it? A couple of meters I recieved
yeterday have that, might need a special wrench to unscrew it, if it does
indeed screw in. It could also be a friction/compression ring; if so I
guess drilling into the notches would help. Just a guess.

Also: I was reading in the 'Pearls' about the solution of the meter face
reproduction problem (using a laser printer). I'd like to make a couple of
Fair Radio replacement meters into useable R390 meters, but to do so, I
need either a scan or high quality photograph of the two dial faces. Does
anybody have these?

David P. Goncalves

>
> Has anyone experience with meters like the one shown at
>
> http://members.aol.com/n4buq/r390a
>
> I want to have it powder coated, but I'm not sure putting it in a 400-deg.
> oven is a good idea.  Does it come apart?  It appears to have a
hard-rubber
> (neoprene?) gasket imbedded in the back.  Does this come out easily?  If
so,
> does it expose the method of disassembly?
>
> I noticed that when I removed the electrical connections on the back, the
> meter movement became loose inside the housing.  Apparently this isn't a
> sealed meter and it should come apart but I havent seen any way to get it
> apart.

_______________________________________________
R-390 mailing list
[email protected]
http://mailman.qth.net/mailman/listinfo/r-390