[R-390] Rack Mounting a R390]

Sun, 27 Oct 2002 14:46:38 -0500

I used a piece of 1" x 1" steel angle to span the back of the cabinet, 
thus supporting the back panel.

The radio is supported on this angle and the front panel screws.

How do you make it all align?  Measure VERY carefully.  Better to be a 
bit low and shim the back so as not to twist the front.

Ron Hunsicker

-------- Original Message --------
Subject: [R-390] Rack Mounting a R390
Date: Sun, 27 Oct 2002 01:23:31 -0500
From: "Michael Young" <[email protected]>
To: <[email protected]>

How do you guys rack mount your R390?  Do you put some angle aluminum in the
sides of the rack for the edges of the R390 to sit on so you can slide it
back into place?   Or do you use full extension slides?

In either case, how do you locate the angles or the slides so the front
panel of the R390' mounting holes line up with the rack's holes?

Or do you just manhandle it with 2 or 3 people and support it entirely with
front panel screws?  (Kinda scary)

THNX

Mikey

_______________________________________________
R-390 mailing list
[email protected]
http://mailman.qth.net/mailman/listinfo/r-390

-- 
Ronald J. Hunsicker, P.E.
1238 Cleveland Avenue
Wyomissing, PA   19610-2102
610-4778-0371
facsimile:  610-478-0453
[email protected]