[R-390] Resistor Tolerances

Mon, 29 Jul 2002 07:45:03 -0400

Well I never buy NOS resistors and certainly not caps.  Baking resistors
before measuring
tolerance is just not the real world, even though most boat anchors do just
that.  :-)
The real question I have is: If the tolerance needs to be held to original
specs on any specific
areas of this set.  I am trying to rely on someone's experience to save me a
lot of
needless work now or in the future.  Most of the TV and radio restoration
work I have
done, +15% is OK, even on a 10% spec resistor,  and I have not had
performance problems as a result.
Of course if a 5% is specifically called for, I will hold it to tighter
tolerances.  Most, if not all, of the resistors seem
to be 10% in my modules and I am thinking that this was just a military
requirement rather than
an necessity.

Thank You,
Scott

----- Original Message -----
From: "JAMES T BRANNIGAN" <[email protected]>
To: "Greg Werstiuk" <[email protected]>; "scott"
<[email protected]>; <[email protected]>
Sent: Monday, July 29, 2002 7:22 AM
Subject: Re: [R-390] Resistor Tolerances

> There was an article in QST several months ago that was a real
"eye-opener"
> about stored resistors.
>
> Jim
>
>
> > Scott -
> >
> > I assume the resistors used in R-390x's are carbon composition.
Moisture
> > absorption alone will shift their tolerance up to about +-20%.
> >
> > When they were more commonly used (20 years ago), I occasionally had to
> > educate customer incoming inspection departments claiming to have
received
> > "out of tolerance" product with the proper method for measuring the
> > resistance value of carbon composition resistors.
> >
> > Among other requirements, before measuring resistance, they must be
baked
> > for a specific period of time at a specific temperature to eliminate
> > absorbed moisture.
> >
> > - Greg
>
>
> _______________________________________________
> R-390 mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/r-390