[R-390] PSK-31

[Barry Hauser]

> Many R-390A's chassis float 20-50V off "ground"

Gee, Jim ....

Correct me if I'm wrong, but I think that should not be allowed.  The
chassis should be grounded using a full three-wire grounded power cord set.
There are a number of old R-390A's around where someone just connected the
neutral and hot with a two-wire cord, but the correct installation is with
the green wire pulled out, fitted with a a solder or crimp-on terminal to a
screw on the rear panel.  The hot should go to the fused/switched side.
Tingles Verboten!


Barry