[R-390] Best way to mount rack rails

[Richard.McClung@Dielectric.spx.com]

The only rack slides for the R-390(*) that I saw/used were in the
AN/TSC-26.  There was a large cast aluminum plate that had counter bored
hole for the screws that mounted the plate to the sides of the receiver and
drilled and tapped holes for attaching the rack slides which were heavy
duty ones made by General Devices.

At fixed sites we  had angle brackets that were bolted to the front and
rear vertical rails and each side of the rack to support the receivers.

I have aluminum angle bracket supporting most my equipment here.  I got it
at the hardware store.  It's Reynolds Aluminum standard stock that comes in
10 foot lengths.

RICH  @B> }

Any rack rail mounting suggestions would be appreciated.
Thanks and 73s, Tom NE7X...