[R-390] Zero Adjust

Sat, 17 Aug 2002 09:15:10 -0700

Tom
Thanks for the response. The front panel screws are all tight.This is one of
Chuck R's radios. There is a lot of travel on the zero adjust so I will
clean the clutch and try again.
Thanks,
Kurt
----- Original Message -----
From: "Tom M." <[email protected]>
To: "Kurt" <[email protected]>; "R-390@Mailman. Qth. Net"
<[email protected]>
Sent: Saturday, August 17, 2002 5:59 AM
Subject: Re: [R-390] Zero Adjust


> make sure all you panel screws are tight, and that the clutch is clean.
You
> can clean it with gumout carb and choke cleaner, then try again.
>
> 73 N5OFF
> --- Kurt <[email protected]> wrote:
> > To the Group
> > Sometime back there was a brief thread concerning nonfunctional zero
adjust
> > mechanisms. I can't find the thread in the archives. Does anyone
remember
> > the details? I have a zero adjust clutch that will not disengage. Any
> > thoughts before I drop the front panel?
> > Thanks,
> > Kurt Holbrook
> >
> >
> > _______________________________________________
> > R-390 mailing list
> > [email protected]
> > http://mailman.qth.net/mailman/listinfo/r-390
>
>
> __________________________________________________
> Do You Yahoo!?
> HotJobs - Search Thousands of New Jobs
> http://www.hotjobs.com
>