[R-1051] Back Panel Plug Diagram

[Ray Fantini]

Why? The two 600 Ohm balanced audio output on radio will exceed just about anything your computers sound card is capable of, just remember to use the line input to the card if it has one. The limiting factor in that radio is the 500 KC IF filters.

Ray F
________________________________________
From: R-1051 [r-1051-bounces at mailman.qth.net] on behalf of Nick England [navy.radio at gmail.com]
Sent: Friday, November 07, 2014 9:06 PM
To: R-1051 Discussion Group
Subject: Re: [R-1051] Back Panel Plug Diagram

Sorry, The rear connectors only have 600 ohm audio out from the AF amps. If you want something earlier you'll have to run a wire into the IF/AF module.

Nick
(phone email acct)


On Nov 7, 2014, at 5:12 PM, Steve Hobensack <stevehobensack at hotmail.com> wrote:

> I would like to feed an external sound card for the digital modes.  I would like to tap the diode
> load or the feeble audio just after the detector and before the first audio amp. Perhaps there is a
> tap that comes out on the multitude connections plug on the back? My book is a maze and ambiguous.
> Thanks
> N8YE
> ____________
______________________________________________________________
R-1051 mailing list
Home: http://mailman.qth.net/mailman/listinfo/r-1051
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:R-1051 at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html