[R-1051] URC-35 - was - Complexity of the 1051

[AI2Q]

John, Randy, et al:

Check my article and comments on the USS Albacore R-1051 project at
http://users.adelphia.net/~alexmm/albacore/restoration.htm

== Alex

-----Original Message-----
From: r-1051-admin at mailman.qth.net
[mailto:r-1051-admin at mailman.qth.net]On Behalf Of John Kolb
Sent: Wednesday, September 17, 2003 1:49 AM
To: r-1051 at mailman.qth.net
Subject: [R-1051] URC-35 - was - Complexity of the 1051


On Tue, 16 Sep 2003, randy zelick wrote:

> Hello CA,
>
> Your email about R-1051 repair caught my interest.
>
> I have a URC-35 that I intend to get going. I have a manual, the RT and
> amp, but no cables. I bought the connectors from Wm Perry and now have
> to make up the cables.
>
> Do you have any advice before I get started?
>
> I have been told that the PA tube is impossible to find and so I should
> pray that the one in my amp is good. It is also unclear if the set will
> run without the matching antenna tuner (which I don't have).
>
> Thanks,
> =Randy=

Any URC-35 repairmen on here? I've also got one - works OK on receive,
but the power supply shuts off when I key it (into dummy), and then
I have to cycle the power switch before it will start again. Any ideas?
No I couldn't find the PA tube either  :)

John