[R-1051] mode switch

[Cecil Acuff]

Hi Steve,

        Did you get any help on the piece of coax that is loose.  I have
been catching up on a week out of town and just got to your email.  I looked
at one in the shop and didn't see the number "4".  There are two black
coaxes on the right side of the switch and two more on the left side.  There
are also two with clear jackets on the left.  One of the black cables on the
left comes around to the right side.  The center conductor of the two on the
right side tie to the same point on the switch.  I took a couple of pictures
if you would like me to send them.

Cecil...
----- Original Message ----- 
From: "Steve Hobensack" <stevehobensack at yahoo.com>
To: "r1051 radio" <r-1051 at mailman.qth.net>
Sent: Saturday, May 17, 2003 4:49 PM
Subject: [R-1051] mode switch


> My r1051b does not work in the CW position. It hears
> signals as if in the AM position. I found an end of a
> piece of minature coax that broke free of the mode
> waffer switch. The other end of the coax goes into the
> wire harness. I am unable to determine where the
> connection is located. The coax has a number "4" on
> it. Are the coax label numbers standard? I have the
> manual. Is there a print that shows the connection and
> the coax id numbers? Main frame schematic figure 5-1
> (page5-35) does not show the coax label numbers.
> Thanks
> ....Steve...KJ8L
>
> __________________________________
> Do you Yahoo!?
> The New Yahoo! Search - Faster. Easier. Bingo.
> http://search.yahoo.com
> _______________________________________________
> R-1051 mailing list
> R-1051 at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/r-1051
>