[Pro2006] OptoScan456 Dip switch settings

[Scott West]

From:  http://wa8pyr.net/optocommand.htm

============================================================================
=
DIP SWITCH SETTINGS
============================================================================
=

There are two DIP switches located on the OptoScan456(tm) circuit board.
SW1 (farthest from the mounting hole) selects the CI-V interface address.
Sixteen different addresses are available.  In order to communicate with the
OptoScan456(tm), the computer software must specify the address selected by
SW1.  The CI-V address switch settings are listed in Table 2 below.  All
addresses are specified in hexadecimal notation.  The factory default
setting, address 80, is shown in bold type.

Table 2.  CI-V Interface Address Dip Switch (SW1) Settings.
===========================================================
1       2       3       4       ADDRESS

OFF     OFF     OFF     OFF     80
ON      OFF     OFF     OFF     81
OFF     ON      OFF     OFF     82
ON      ON      OFF     OFF     83
OFF     OFF     ON      OFF     84
ON      OFF     ON      OFF     85
OFF     ON      ON      OFF     86
ON      ON      ON      OFF     87
OFF     OFF     OFF     ON      88
ON      OFF     OFF     ON      89
OFF     ON      OFF     ON      8A
ON      ON      OFF     ON      8B
OFF     OFF     ON      ON      8C
ON      OFF     ON      ON      8D
OFF     ON      ON      ON      8E
ON      ON      ON      ON      8F

SW2 (closest to the mounting hole) selects the CI-V interface data rate.  In
order to communicate with the OptoScan456(tm), the data rate of the computer
serial port must match the data rate selected by SW2.  The CI-V data rate
settings are listed in Table 3 below.  The factory default setting, 9600
bps,
is shown in bold type.  The 9600 bps data rate is strongly recommended, as a
lower data rate will impair scanning speed.

Table 3.  CI-V Interface Data Rate Dip Switch (SW2) Settings.
=============================================================
1       2       3       4       DATA RATE

OFF     OFF     OFF     OFF     75 bps
ON      OFF     OFF     OFF     110 bps
OFF     ON      OFF     OFF     150 bps
ON      ON      OFF     OFF     300 bps
OFF     OFF     ON      OFF     600 bps
ON      OFF     ON      OFF     1200 bps
OFF     ON      ON      OFF     2400 bps
ON      ON      ON      OFF     4800 bps
OFF     OFF     OFF     ON      9600 bps
ON      OFF     OFF     ON      19200 bps
OFF     ON      OFF     ON      38400 bps
ON      ON      OFF     ON      unused
OFF     OFF     ON      ON      unused
ON      OFF     ON      ON      unused
OFF     ON      ON      ON      unused
ON      ON      ON      ON      unused

-----Original Message-----
From: pro2006-bounces at mailman.qth.net
[mailto:pro2006-bounces at mailman.qth.net] On Behalf Of Paul Roberts
Sent: Saturday, December 29, 2007 8:58 PM
To: Pro2006 at mailman.qth.net
Subject: [Pro2006] OptoScan456 Dip switch settings

Hello everyone,
 
I've got a pro-2006 with a OS456.  I'm getting ready
to change computers but I need to change the com port
settings on the board first and I can't find the
paperwork that came with the OS456.  Would anyone have
a copy that they could send me or at least tell me how
to set it for com port #1.

Thanks,
Paul