[Pro2006] Flashing battery warning and beeping

Tom Hirsch thirsch4 at juno.com
Sun Aug 12 17:53:37 EDT 2007


Hello from Central Florida,

  The likely causes of your problem

1.  break in the wire from the 9 volt snap-in battery to the circuit board.   This problem has happened to at least one of my scanners.  Get a known good connector with leads longer than needed, and carefully note the connections of the existing wiring.  Unsolder the current wires, and replace with a new snap connector and wiring.

2.  Failure of the low battery detection circuit.  You'll need someone with better electronics knowledge than mine to fix this issue.

  I don't know of any way to shut off the low battery beep and the flashing indicator in the display.

  Good luck



More information about the Pro2006 mailing list