[Premium-Rx] Rohde and Schwarz ESM 1002 Receiver and DF systems

[greenjr]

Hi

I'm now the owner of an R&S ESM 1002 VHF/UHF receiver which I want to 
control from a GB 501 controller.  However I don't have much information 
on either unit so I an unsure how to connect them.  Each unit has an IEC 
625 /IEEE-488 /GPIB connector.  In addition the Receiver has a 
Centronics 24-pin female connector marked Eingange/Ausgange and the 
controller has a similar connector marked Ausgange.

Any assistance as to which of these connectors are the ones to use and 
wiring details, switch settings etc would be very helpful.

In addition I have nearly all the units needed to make up an R&S PA055 / 
PA555 VHF/UHF direction finding system:

ESM 500 receiver
GX055 Junction Unit

PG555 and PG055 Scanning Units
PP055 DF and Display unit

AP555A1 and A2 Doppler DF antennas
PV017 Azimuth analyser

   However I have none of the inter-connection cables and I only have 
manuals for the ESM500, the PP055, the AP555A1 and the overall PA555 
system.  Is there anyone out there in Premium Receiver land who has 
managed to get one of these systems connected up and working?  May be 
best to reply off-list on this one as it is a bit off-topic for the 
list.

Regards

John