[Premium-Rx] Problem with my long-wire with balun 4:1

[Fernando]

Hi Joseph, 

My guess is your balun is not working as it should.
The LED lights at home lighting indicate that there is RF coming back through your coax, when you transmit. I believe that, in fact, RF is not getting past your balun and that you are radiating with your coax.  
In my view, there are several possibilities: mechanical problem (LW and balun are not making the necessary contact) or fried balun, which is rare but happens now and then (i.e. if at some point there has been a very heavy thunderstorm with lightning falling nearby).

Just my 2 cents. Good luck my friend, and best wishes to you and yours

73

Fernando EA4BB

 

> El 20 abr 2020, a las 9:10, joseph.bozzer at skynet.be escribió:
> 
> I don’t understand what’s happened with my 80m long-wire since I installed a balun 4:1 on it
> 
> In 20 meter i’ve a SWR <1,5
> In 40 meter i’ve a SWR 1,5 =< 2 
> In 80 meter i’ve a SWR <5
> 
> With the ATU of my FTDX5000 I put all them to 0 but I have a big problem:
> - On 40 and 80m all is ok .. I’ve very good results in transmission
> - But on 20m it’s a disaster … some LED lamps in my house start to flash at the rate of my CW and the monitoring sound on my FTDX5000 becomes very raucous
> 
> It's impossible to use my Long-wire in 20m
> What's is happen? ... I remind you that without ATU the SWR is <1.5 over 20m
> 
> 
> 
> 
> 
> ______________________________________________________________
> Premium-Rx mailing list
> Home: http://mailman.qth.net/mailman/listinfo/premium-rx
> Help Page: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Premium-Rx at mailman.qth.net
> Help Contact eMail:  radio at 8zo.com
> Home Page:  http://www.premium-rx.org/