[Premium-Rx] WJ-8711A Main Tuning Encoder

[fintronics]

Hello;

This has probably been covered before but I can't seem to find it in the
archives.

I have a 8711A that has a slight wobble on the main tuning knob/encoder. I
actually have two with the same condition as well as an 8718. It's by no
means objectionable and you don't feel it when you're tuning around. Is
there some way to tighten this up? Is it the encoder? front panel
bushing?.. don't know.. I remember reading that there are different types
of encoders for these but not sure the difference. If it is in fact the
encoder, can it be re-built? Are there replacements available? (doubtful).

Any help or suggestions would be greatly appreciated.

Thank you.

Glenn W2BX