[Premium-Rx] Racal Receiver OCXOs

[Michael O'Beirne]

Dear Dan

The 9442 Racal-Dana standard is known for failure.  I had the same problem. 
In the end Pat McA G3YFK sent me an ITT TXCO (that fits on the BFO board 
from memory) and it does all I require and has fully satisfactory stability, 
both short term and long term.

73s
Michael
G8MOB

----- Original Message ----- 
From: "Dan Rae" <danrae at verizon.net>
To: <premium-rx at mailman.qth.net>
Sent: Saturday, April 16, 2011 5:34 PM
Subject: [Premium-Rx] Racal Receiver OCXOs


>I have just repaired the second 9442-12 rapid warm up oven to have
> failed in an RA1792 here.  One might not be a cause for concern but two
> going worries me :^)
>
> In both cases it was the ceramic (?) capacitor that is in parallel with
> the trimmer that failed or changed value.
>
> In the first one the fine wires that lead from the PC board to the base
> had PVC insulation that had hardened and gone brittle as well.  The
> second one seems to have PTFE covered wiring.
>
> I have spread it around a bit already but I do have a rough circuit
> diagram of the thing if anyone is faced with the same problem.
>
> Dan
>
> ac6ao / g3ncr
> ______________________________________________________________
> Premium-Rx mailing list
> Home: http://mailman.qth.net/mailman/listinfo/premium-rx
> Help Page: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Premium-Rx at mailman.qth.net
> Help Contact eMail:  paul at 8zo.com
> Home Page:  http://www.premium-rx.org/