[Premium-Rx] Cubic R3091

[Chuck Urmson]

Hi Steve,

I was one of the many people who asked him to confirm what the frequency 
coverage was.  I asked because the R-3090 is a 0-500kHz (only) dual 
receiver.  I therefore assumed, it now seems correctly, that the R-3091 
was the single receiver version of that. 

As far as the manual goes is it specifically for the R-3091?  I ask 
because the R-3080 manual is available on the Premium RX site already so 
there would be no point in scanning it otherwise. 

Finally if you do decide that you are unhappy with the frequency 
coverage I may be interested in taking it off your hands.  I was the 
bidder that came second! 

Regards,
Chuck
M1DPD

s wrote:
> Hello Guru's
> I just purchased this from the e place I haven't been able to tune it 
> above 500Khz and it's vlf /hf.I was wondering if someone is familiar 
> with this set i'm using it in local mode as i have no software.So 
> either it's faulty or i'm not settting it up right,.I tried manually 
> entering frequencies in on the numeric panel and it doesn't accept 
> anything higher than 500khz on that either.The seller says he never 
> used it above 500k's hmm have i been sold a pup!One upside though is 
> it came with the full service manual with diagrams unfortunately i 
> haven't scanned it yet but when i have for a limited time and postage 
> cost i will make it available to members who want it.All the other 
> functions on the front panel are working fine and all the modes and 
> bandwidths work.I've seen the recent posts about cubic not being 
> particularly co operative with info on older sets.I suspect they want 
> to keep there street cred with spooksville.Any help appreciated thanks.
> B.R
> Steve E
> _______________________________________________
> Premium-Rx Mailing List
> To Post: premium-rx at mailman.qth.net
> For Info: http://mailman.qth.net/mailman/listinfo/premium-rx
> Visit the Website: http://www.premium-rx.org
> Email Help: paul at premium-rx.org
>
>
>
>