[Premium-Rx] Harris RF-230 transceiver info wanted. (follow up)

[Hans.Hamradio]

Hi Premium RX friends.

To keep you informed about my RF-230 Harris transceiver request I can inform 
you that the transceiver is working again after replacing a couple a the 
famous blue tatalium caps.(zero Ohm!!) Secondly the 13Mhz xtal oven was 
wrongly/out of range.
Still some work to do but the tip of the groupmember to look also under the 
covers on the decadeswitch board was the major thing to look after.

Still no manual or schematic so that's on the wishlist.

To finish the job i am very interest to have the USB filter for LSB use. It 
is the same filter as fitted in the Harris receiver RF-530A and should be 
rated 9.0015 khz which is the same as used in some ten tec transceivers. The 
marking on the Harris filter is PTI-model 5321/FL-0135/9.0Mhz USB.
Please let me know if you have one left in the junkbox. If interested I can 
supply the detailed pictures off line.

Thanks again for your support and looking forward to the positive mail.

Hans PA1AMS-AMSterdam NL.


----- Original Message ----- 
From: "Hans.Hamradio" <hans.hamradio at lycos.nl>
To: <premium-rx at mailman.qth.net>
Sent: Friday, October 26, 2007 9:28 AM
Subject: Repeat!! [Premium-Rx] Harris RF-230 transceiver info wanted.


> Hi Premium RX friends
>
> Still no reply on my request dated 07 Oct. 2007.
> I do not need a full manual but a small scan of the schematics will do the 
> repair job. Assume a power problem on the supply board.
> Got only a reply of intentions to make a copy. Your cooperation is very 
> much appreciated.
>
> 73 H at ns PA1AMS
>
> To: <premium-rx at mailman.qth.net>
> Sent: Sunday, October 07, 2007 4:17 PM
> Subject: [Premium-Rx] Harris RF-230 transceiver info wanted.
>
>
>> Hi Premium RX friends.
>>
>> Just obtained a very nice Harris RF-230 transceiver without any damage 
>> and in excellent mechanical  condition and ex.LSB (missing 9 MHZ 
>> USBfilter). However!! There was a short in a tantalium C. (33mf/25Volt) 
>> in the board fitted in the slot direct behind the front. After replacing 
>> it was working for 30 minutes.(Rx current now 0.7A instead of 1.7A under 
>> working conditions). Before starting another repairjob I like to know if 
>> the group can help me with the schematics. A link or pdf prefered.
>> Tnx in advance,enjoy the hobby and greetings from Amsterdam NL.
>>
>> H at ns PA1AMS
>>
>> _______________________________________________
>> Premium-Rx Mailing List
>> To Post: premium-rx at mailman.qth.net
>> For Info: http://mailman.qth.net/mailman/listinfo/premium-rx
>> Visit the Website: http://www.premium-rx.org
>> Email Help: paul at premium-rx.org
>>
>>
>
> _______________________________________________
> Premium-Rx Mailing List
> To Post: premium-rx at mailman.qth.net
> For Info: http://mailman.qth.net/mailman/listinfo/premium-rx
> Visit the Website: http://www.premium-rx.org
> Email Help: paul at premium-rx.org
>
>