[Premium-Rx] software based IF spectrum monitor/panadapter?

[Eugene Hertz]

This discussion got me ta thinkin...

Anyone know of a spectrum analyzer software with some kind of ADC board (ie higher freq than audio board) that can be connected to the IF out on a receiver (say 455)??  I guess short of buying an expensive pc-o;scope/spectrum analyzer..something simpler, you know, poor man's pc-panadapter

Eugene



>-----Original Message-----
>From: Alberto di Bene [mailto:dibene at usa.net]
>Sent: Tuesday, October 5, 2004 08:41 AM
>To: premium-rx at ml.skirrow.org
>Subject: [Premium-Rx] RE: Receiver Frequency Display Accuracy & Calibration
>
>"Gary Mitchelson - N3JPU" <n3jpu at speakeasy.net> wrote: 
> 
>> MixW will display 1HZ resolution. Now this all 
>>relays on the soundcard to be fairly accurate, and the USB and LSB 
>>oscillators to be set the same. But if the USB and LSB tone is the same on 
>>the spectrum display I think you have it close. Then you can calibrate the 
>>display. 
>> 
>> 
> 
><shameless-plug> 
>In case you need a better resolution than 1 Hz you can try Spectran, 
>found here : 
>http://www.weaksignals.com 
></shameless-plug> 
> 
>73 Alberto I2PHD 
> 
> 
> 
>_______________________________________________ 
> 
>Premium-Rx Mailing List 
>To Post: premium-rx at ml.skirrow.org 
>For Info: http://ml.islandnet.com/mailman/listinfo/premium-rx 
>Visit the Website: http://kahuna.sdsu.edu/~mechtron/PremRxPage/ 
>