[PCR-1000] ex2099 software - Think I'll give it a try

[robert.mc at att.net]

Oh yeah, S/N of this radio is 001310, and may have been a Japanese model originally, it has the mysterious UT-107 installed, but does nothing as you might expect.

Will send the EEProm data tomorrow to those that requested.  Be advised I will prolly go through the exercise again, or at least verify levels over the span to spot any irregularities.

Bob

-------------- Original message from robert.mc at att.net: -------------- 


> Well, up and did it, went through the ex2099.exe calibration routine. More 
> exactly, went through is several times. Dunno how much better it works now, but 
> a lot of small things like S-Meter flatness over frequency were off a bit. As 
> far as sensitivity, none of the BPFs were off much, but I found quickly that 
> things happen without apparent reason in the software: values magically changing 
> to very high values. I might have been doing it, but damned if I can see what. 
> Ended up going throug the thing over and over until the bogus entries were 
> vanquished. The Xtal was only off a few Hz, did not bother diddling it. 
> 
> PCR1000BUR reported 9 values out of tolerance before tuning, now reports 22! 
> But, I am fairly sure I set everything correctly, so this is just where things 
> end up with this early version radio. If anyone want the EEPROM data to 
> compare, I'll send it to them. 
> 
> Bob 
> 
> ______________________________________________________________ 
> PCR-1000 mailing list 
> Home: http://mailman.qth.net/mailman/listinfo/pcr-1000 
> Help: http://mailman.qth.net/faq.htm 
> Post: mailto:PCR-1000 at mailman.qth.net