[PCR-1000] antenna heating

Tue, 21 Jan 2003 15:04:55 +0200

Thanks
When i get home from work i will measure and post the results
it is great that there is a forum that help so much
Matty

-----Original Message-----
From: mikea [mailto:[email protected]]
Sent: Tuesday, January 21, 2003 1:57 AM
To: [email protected]
Subject: Re: [PCR-1000] antenna heating

On Mon, Jan 20, 2003 at 05:05:53PM -0500, Al Simcoe wrote:
> With an ohm meter, measure across the center conductor of the Antenna
> Input and its ground. You should measure 0 ohms. 
> 
> Even a dead short would do this. Are you sure your new 50 m  dipole
> isn't connected to
> 120 ac?  :)

First -- *FIRST* -- measure the AC voltages on everything!

Turns out that the Cable TV system ground here is about 30 VAC
away from the power company's house ground. Cable tech really 
didn't like getting zapped - especially as it was hand-to-hand
through the chest. 

I really suspect something peculiar in the wiring.

-- 
Mike Andrews
[email protected]
Tired old sysadmin since 1964
_________________________________________________________________
PCR-1000 Mailing List
Post Address: [email protected]
Subscribe / Unsubscribe: 
http://mailman.qth.net/mailman/listinfo/pcr-1000
Mailman FAQ and Users Guide
http://mailman.qth.net/faq.htm