[PCR-1000] packet output

Sat, 01 Feb 2003 12:29:03 -0700

Quick question, can we possibly record one source and monitor on the 
other. I'm running XP and can set Capture to microphone and use packet 
output. I can then set Volume Control to mute the microphone and listen 
to Line In which is connected to Speaker Output. TalkPCR then records 
passes using the Capture setting as evident by the changes in TalkPCRs 
reording levels when I adjust the Microphone levels in Capture.

Next question do I have the right source plugged into the right input - 
Packet to Mic and Audio to Line In? I am very new to all this, using 
packet output should I be hearing a lot of static ?

I seem to get one great image a day from NOAA 17 and all the others , 
both passes and satellites are full of artifacts and static or worse. Of 
course that could be the fact the antenna still sits on a low wall in 
front of a thick house :-)

John

Jim Shaffer wrote:

>On Saturday 01 February 2003 02:30 am, Brian Winter wrote:
>  
>
>>>>.... because I had such terrible luck decoding ACARS that I gave up on
>>>>it.
>>>>        
>>>>
>>did you try ANAD / POSFIX / WACARS combination.  i got better results with
>>this than with WACARS alone
>>    
>>
>
>No, I only tried WACARS.
>
>_________________________________________________________________
>PCR-1000 Mailing List
>Post Address: [email protected]
>Subscribe / Unsubscribe: 
>http://mailman.qth.net/mailman/listinfo/pcr-1000
>Mailman FAQ and Users Guide
>http://mailman.qth.net/faq.htm
>  
>

-- 
John Lang, 
E-mail: [email protected] 

BrightNoise Inc.,
16111 East Carmel Drive,
Fountain Hills, AZ 85268
Tel: (480) 837-5483, Fax: (480) 837-5189