[PaQSO] county lines on fjp program

[Hank Greeb]

If the PAQSO module is like the Illinois version, you log each county in 
a new line when you are in a single county and working a multi county 
line station.

IF you're on a county line, the IlQP version asks you to list all the 
counties in the setup, then when you work a single county station, it 
automagically makes two to four lines in your log (In Illinois you may 
operate from a "corner" where four counties meet.)

I downloaded the N3FJP PAQP version 2.2, and it appears that it works 
eggaktly like the ILQP version.  When you're on a county line, you enter 
one of the counties in initial setup, then do a "Change county" and 
there's a place for adding multi counties.

I was on a four county corner a few years back in Illinois, it really 
helped to have paper on hand when one ran across another multi county 
line station. :)

72/73 de n8xx Hg
QRP >99.44% of the time

On 9/19/2012 10:52 PM, Larry G wrote:
> Greetings.....how do you do county lines on the N3FJP
> program???  Not control Y or anything similar.  Thanks n3cr