[OKDXA] EDZ

Wed, 06 Nov 2002 04:26:49 -0600

Let me run this up the flag pole.
Say i got a remote antenna switch the outdoor type,
It has three PL conectors female, now I install one each male male conector
to all three.
Then I install one each balun, the type of 1:1 normaly used in the G5RV.
How close am I to outdoor switch? This is the part where i got lost, not
sure if the switch itself should be ballanced to provide best results.
Keep in mind that this is for a EDZ rez on one band.
Tune feed for two other bands.
PS, If the group would rather we can go simplex.
Take care.
Jim ad5kd
----- Original Message -----
From: "Terry R. Hackworth" <[email protected]>
To: <[email protected]>
Sent: Tuesday, November 05, 2002 10:47 PM
Subject: [OKDXA] EDZ


> Nelson, AC5UP,
>
> Sir, could you please email me direct.  I have a question before ordering
> some parts regarding your Extended Double Zepp antenna.
>
> I sent an email to your published address and the servers seem to be
holding
> it, or at least that is what they report to me.
>
> Many thanks,
>
> Terry R. Hackworth
> [email protected]
>
> _______________________________________________
> OKDXA mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/okdxa