[NvHam] Kenwood rig FS

[Jack/NA7RF]

I have a TS-930SAT transceiver available. It covers 160 through 10 
meters and has general coverage receive capability from 150kHz to 30MHz. 
In addition to the automatic antenna tuner it includes both the 2nd IF 
(8.3MHz) and 3rd IF (455kHz) CW filters...the 2nd IF being the 500Hz 
Kenwood filter and the 3rd IF is an INRAD 400Hz filter. The power supply 
is built into the rig which makes it a bit heavy (about 41 pounds).

Also included are both the operating manual and the service manual and a 
Heil Sound BM-10 boom headset/microphone. The BM-10 is well used but 
works fine. I have also printed, and included in the service manual, 
many of the available mods for the rig. I have never done any of them, 
primarily due to the fact that the rig works well unmodified.

Although the rig is an early serial number (3060489) I have had 
absolutely no problems with the rig which has worked very well in both 
casual and contest operation. The CW filters are exceptional and the 
receiver front-end allows me to operate within a few kHz of another 
station located a couple of miles away running around 600 watts...the 
front-end is, essentially, crunch-proof! The TS-930SAT shows some wear 
but is in reasonable condition for a 20-year-old rig.

I am asking $450.00 (firm) for the rig with both CW filters and $350.00 
without the CW filters. I am not going to ship this rig, so local pickup 
in Silver Springs, NV, is necessary.

I also have a DenTron 160-10AT antenna tuner for sale. I have used the 
tuner on various bands, including tuning a 160-meter inverted-L, and it 
works well. A copy of the DenTron instruction booklet is included, 
Asking $65.00 (firm) plus shipping from 89429.

Thanks,

Jack, NA7RF