[NLRS] Neat tip for those building W1GHZ transverters

[Scott]

Today at work, I was using some of those two pin Molex connectors from 
Radio Shack and I noticed the shiny metal strip that the pins come 
attached to (and take solder nicely) are the same width as 50 ohm strip 
line on the G-10 boards.  These will make nice "jumpers" between the RF 
output of the transverter board and the relay board and should provide a 
minimal impedance bump, I would think.  Nothing Earth shattering, but 
just thought it would be nicer than just a piece of bare bus wire...

-- 
Scott N0EDV
http://corbenflyer.tripod.com/
Flying Corben Junior Ace - Building RV-4
Gotta Fly or Gonna Die