[NLRS] Soldering Topside ?

[Melvynkc0p at aol.com]

I am assembling a Down East T/R  Sequencer. It has all pin thru hole 
components
and plated thru holes.  Instructions say all components go on the topside. 
Fine.

They also say  the components can be soldered from the top side. What is the
significance of  that ? It looks to me like I can do a better job of 
soldering on the
back  side (less chance of solder bridges). It seems to be wicking the solder
along  the component leads thru the hole to the top side just fine and no
bridges so  far.

Any suggestions ?

73 Mel (hot solder) KC0P






**************It's only a deal if it's where you want to go. Find your travel 
deal here.      
(http://information.travel.aol.com/deals?ncid=aoltrv00050000000047)