[NLRS] K0MHC/R revised schedule- please note the time changes

jim.k0mhc jim.k0mhc at earthlink.net
Fri Aug 5 08:32:40 EDT 2005


I've had to reverse my route to pick up another day to solve a pre-amp 
problem. So, I've recalculated the times (CDST) listed below. Baring any 
detours, etc. I hope to be on-time. I'll be out in the sticks most of the 
time so please crank up the analog DSP between your ears.

I wish that I could operate longer in each grid but set-up, take-down and 
travel times cut into the overall schedule. I'll only be operating while 
stopped at these locations with the antenna mast elevated. A modified 
antenna setup will provide separate yagis so as to improve my chances of 
hitting the Twin Cites from these locations (depending on propagation and 
site selection).

Bands will include 222-3456 MHz on the mast and 5.7-10 GHz (QRP) with a 
portable dish for local contacts only.

You can look my way on 222.125, 432.125 during these times and on these 
bearings (from the Twin Cities):

GRID...START-END... TWIN CITIES BEARING  (Times are CDST), LOCATION
EN25ax  13:00-14:00  ~298',  ~150 miles, near Elbow Lake, MN
EN26aa  14:30-15:30  ~298',  ~150 miles, near Elbow Lake, MN
EN16xa  16:00-17:00  ~298',  ~150 miles, near Elbow Lake, MN

EN15xa  19:00-20:00  ~270',  ~134 miles, near Madson, MN

EN14xa  22:00-22:45  ~243',  ~150 miles, near Woodstock, MN

EN13xa   00:45-01:30  ~225', ~192 miles, near Alton, IA
EN23aa   02:00-03:00  ~225', ~192 miles, near Alton, IA
EN22ax   03:30-04:30  ~225', ~192 miles, near Alton, IA
EN12xx   05:00-06:00  ~225', ~192 miles, near Alton, IA

EN02xa   09:00-10:00  ~230', ~317 miles, near Elgin, NE
EN01xx   10:30-11:30  ~230', ~317 miles, near Elgin, NE
EN11ax   12:00-13:00  ~230', ~317 miles, near Elgin, NE

Thanks again to Jon for coordinating this event!
Looking forward to working everyone that I can hear on 222.125 and 432.125.
Sorry for the last minute schedule changes.

73, Jim
K0MHC/R

"ROVING; SOME ASSEMBLY REQUIRED?"




More information about the NLRS mailing list